Skip to content
VisionGreen

Energy for pharma and medtech

A regulated site cannot switch things off on a whim. It can stop paying for energy that validation never required, and that starts with measuring HVAC, clean utilities and compressed air properly.

Where the energy actually goes

HVAC and clean rooms

Air changes and setpoints held at production levels around the clock, including in areas that are idle. Measured setback in validated areas is often the largest single saving.

Clean utilities

Purified water, clean steam and chilled water loops running at full duty whatever the demand.

Compressed air

Leaks and pressure set higher than any process needs, feeding the site through nights and weekends.

Process and lab equipment

Freezers, autoclaves, ovens and fume hoods, metered circuit by circuit to separate what is needed from what is habit.

What the data usually catches first

Most pharma and medtech sites use more than 2.8 GWh a year, so they need a mandatory energy audit every four years unless they hold ISO 50001. We carry out both.

  • HVAC holding production setpoints in idle suites
  • Chillers and boilers running in parallel when one would do
  • Compressed air demand that never falls at night
  • Equipment drifting from its validated performance before it fails

Common questions

Who can help a pharmaceutical or medtech site in Ireland cut energy use and get SEAI EXEED funding?

VisionGreen works with pharma and medtech sites on energy monitoring, mandatory energy audits and EXEED projects. EXEED funds up to 50% of the design work and up to 30% of the capital cost of a designed energy project (40% for heat pumps), up to €3 million per project.

Does a pharma site in Ireland need a mandatory energy audit?

Most do. Under the Energy Efficiency Directive, businesses using more than 2.8 GWh of energy a year must carry out an energy audit every four years, unless they run a certified energy management system such as ISO 50001.

Can energy monitoring work on a validated GMP site?

Yes. The meters clamp onto existing circuits in the distribution boards and only measure; they do not control anything, so they sit outside validated systems. The data then supports change control for any setback or schedule change.

Can you help a pharma site get ISO 50001 certified?

Yes. ISO 50001 needs measured energy data, significant energy uses identified, targets and a review cycle. Our monitoring and monthly energy management provide most of the evidence, and we help build the rest of the system for certification.

Start with an audit. The SEAI pays €2,000 of it

If you spend over €10,000 a year on energy, the Support Scheme for Energy Audits covers most of the cost. An engineer walks the site and writes up what to fix and what it returns.

Call usEnquire